Reverse osmosis vs distilled water is really a question about where the work happens. A membrane rejects dissolved solids under pressure. A still boils the water away from everything in it and catches the vapor. Both can turn an ordinary tap into something close to pure, but they get there on different budgets, in different amounts of time, and with different blind spots. I am not a certified water treatment professional, so none of this replaces a lab test if you already suspect a specific contaminant. Here is the arithmetic and the chemistry that actually separate the two, not marketing copy from either side.

At a glance

  • About 2.7 kWh is the physics-based floor to boil one gallon dry, roughly 49 cents at the 2026 average US electricity rate
  • Zero extra electricity is what a standard reverse osmosis system needs, since it runs on the house’s own line pressure
  • VOCs with a low boiling point can travel with the steam in a simple still, per university extension and EPA guidance
  • NSF/ANSI 58 is the rejection standard an RO membrane is actually held to, not a number off a sales page
In this guide

Reverse Osmosis vs Distilled Water: Two Different Separations

Reverse osmosis pushes feed water through a semi-permeable membrane under pressure. Water molecules pass; most dissolved salts, metals, and larger organic molecules do not, and they get flushed down the drain with the reject stream. Nothing gets heated and nothing changes state. The whole process depends on feed pressure doing the work, which is why a weak supply line throttles output long before any filter does.

Distillation works on boiling point instead of molecule size. Heat the water until it turns to vapor, leave behind anything with a boiling point high enough to stay liquid, then cool the vapor back into water in a separate chamber. Salts, minerals, and heavy metals almost never travel with the steam, because their boiling points sit thousands of degrees above water’s. That is the strength of distillation and also where its one real weakness starts, covered below.

The Energy Math: What Boiling a Gallon Actually Costs

Vendor pages throw around cost-per-gallon numbers that vary by a factor of five depending on who is selling what. The honest way to compare the two is to work the physics directly, with the assumptions stated, rather than repeat somebody else’s marketing arithmetic.

Cost to vaporize one gallon, stated assumptions

assume tap water at 65F, 8.34 lb per gallon, no heater losses
raise to 212F: 147F rise x 1 BTU/lb-F x 8.34 lb = 1,226 BTU
boil it off: 970 BTU/lb (latent heat) x 8.34 lb = 8,090 BTU
total = 9,316 BTU = 2.73 kWh, ideal case only

at 18 cents/kWh (EIA's 2026 average US residential rate)
2.73 kWh x $0.18 = $0.49 per gallon, a floor, not a ceiling

That 49 cents assumes a perfectly efficient heater and a condenser that costs nothing to run, which no real countertop unit achieves. Insulation losses, a fan or pump on some models, and a feed temperature colder than 65F in winter all push the real number higher, never lower. A standard reverse osmosis system, by contrast, draws zero additional electricity for the separation itself. It sits on the household’s existing water pressure, the same pressure that already fills a glass at the tap. The only electrical load anywhere in the system is a booster pump, and only on the minority of homes where feed pressure runs low enough to need one.

Scale this to a family drinking and cooking with a gallon or two a day and the gap compounds fast. A still run daily can add real dollars to a power bill over a year; an RO system’s operating cost is almost entirely cartridges and membrane replacement, detailed in the real filter schedule and yearly cost for reverse osmosis, not electricity.

What Distillation Leaves Behind, and What It Lets Through

Distillation’s reputation for near-total purity is earned against dissolved minerals, heavy metals, and most microorganisms, since cell walls do not survive boiling and metal ions do not vaporize. It is weaker against a specific category: volatile and semi-volatile organic compounds. The University of Nebraska-Lincoln Extension’s water testing guide names the mechanism directly: solvents and VOCs such as benzene and toluene, with boiling points close to or below that of water, vaporize along with the water and can ride the steam straight into the collection chamber.

An EPA New England fact sheet distributed through UMass Extension makes the same point about distillation treatment systems: certain volatile and semi-volatile organic compounds may not be removed by distillation at all. Connecticut’s Department of Public Health goes further in its guidance for private well owners, recommending that VOCs be removed before water reaches a distiller, since otherwise they can be carried along with the steam and recontaminate the output. None of this applies to the minerals, nitrate, arsenic, or lead that distillation handles well; it is specific to compounds that boil at or below water’s own boiling point.

Two things reduce the problem in practice. A carbon filter after the still, or venting the still during the first few minutes of preheating, pulls out most of the volatile load before it reaches the collection chamber. Neither fix is built into every countertop unit sold, so it is worth checking a specific model’s documentation rather than assuming.

What Reverse Osmosis Rejects, and Where It Falls Short

A residential RO membrane is sized against NSF/ANSI 58, the standard that sets a rejection floor for a system sold as “reverse osmosis,” covered in more detail in how long a reverse osmosis membrane actually lasts and what decides it. Unlike distillation, membrane rejection works by particle size and charge rather than boiling point, so it catches a wide range of dissolved salts, nitrate, arsenic, and lead while it is still working correctly.

  • Dissolved salts, nitrate, arsenic, and most heavy metals: rejected by the membrane while it is intact and within its rated life
  • Chlorine taste and odor: handled by the carbon pre-filter stage ahead of the membrane, not the membrane itself
  • Some dissolved gases, and compounds with a molecular weight similar to water, can pass through at a lower rejection rate than salts do
  • Bacteria and viruses are mostly excluded by an intact membrane, but RO is not certified or sold as a disinfection step

The failure mode is different from distillation’s, too. Rejection does not fall off a cliff; it drifts downward as the membrane fouls, which is exactly why checking TDS rejection with a cheap meter catches a tired membrane before anyone notices a taste change. A still does not have that same slow drift. It either boils and condenses correctly or it does not.

Minerals, Taste, and the Remineralization Question

Both methods strip calcium and magnesium along with everything else, and both can leave drinking water tasting flat to people used to tap or spring water. Distillation removes minerals more completely, since nothing with their boiling point can travel with the steam under normal operation. RO removes most of them but not all, since a membrane’s rejection of calcium and magnesium is strong but not perfect even when new.

Neither flat taste points to a safety problem. A US diet gets the overwhelming majority of its calcium and magnesium from food, not from tap water, so stripping both out of drinking water changes taste, not nutrition. For RO specifically, a cartridge can add a small, controlled amount of mineral content back in; what it changes, what it costs, and when it is worth fitting is covered in remineralizing RO water. Distillers rarely offer the same option, since there is no equivalent post-treatment stage built into most countertop units.

A cylindrical water filter cartridge standing beside a full glass of clear water
A membrane or cartridge does its rejecting at room temperature; a still does its separating at a rolling boil.

Waste Water and the Other Side of Both Methods

Reverse osmosis is well known for sending reject water down the drain, usually more than it delivers as product water on an older or undersized system. The actual ratio, what changes it, and the WaterSense-labeled alternative are worked through with real numbers in how much water reverse osmosis actually wastes. That reject water carries the rejected minerals away in liquid form, so there is nothing solid left to clean out of the unit itself.

Distillation sends nothing down the drain during the boil, but it does not make the leftover minerals disappear. They concentrate into a scale residue stuck to the bottom of the boiling chamber, and that chamber needs to be scrubbed out by hand on a regular basis, more often on hard water than soft. Skip the cleaning and the scale layer insulates the heating element, which makes every later gallon take longer and cost more to boil, on top of the baseline energy math above.

Reverse Osmosis vs Distilled Water, Side by Side

FactorReverse osmosisDistillation
How it separatesPressure through a membraneBoiling, then condensing the vapor
Extra electricityNone, beyond an optional booster pumpAbout 2.7 kWh per gallon, floor only
MineralsMostly rejected, some pass throughAlmost completely left behind
Low-boiling VOCsLargely rejected by the membraneCan travel with the steam untreated
Leftover residueLiquid reject water down the drainMineral scale inside the chamber
Ongoing upkeepCartridges and a membrane on a scheduleManual descaling, no membrane to buy

Where Each One Actually Makes Sense

Where reverse osmosis fits

  • Daily drinking and cooking water for a household, delivered continuously off line pressure
  • Homes already on treated city or well water, where the main job is polishing, not disinfecting
  • Anyone who wants the option to remineralize, or to scale the install to a whole house later

Where distillation fits instead

  • Small-volume, near-total mineral removal: a CPAP humidifier, a steam iron, or a lab-style use at home
  • No access to a pressurized supply line or a drain to plumb a membrane system into
  • Water with confirmed high mineral content and no VOC concern, where flat taste is an acceptable trade

Neither one is the right default for every kitchen, and neither replaces the other’s upkeep: an RO membrane still needs its pre-filters changed on schedule, and a still still needs its chamber descaled by hand. Picking between them is less about which removes “more” in the abstract and more about which failure mode and which ongoing chore you would rather live with.

Checking What You Actually Need Before Buying Either One

Start from what is actually in the water, not from a marketing claim about which process is “better.” A certified lab test for the contaminants plausible in your area, well or municipal, tells you whether the concern is minerals, nitrate, arsenic, a solvent, or nothing at all. If the result points at a VOC or a solvent, distillation alone is the weaker choice unless it is paired with carbon filtration; a membrane sized to NSF/ANSI 58 generally handles that case better on its own.

If the concern is mainly dissolved minerals and the household already has a pressurized supply line and a drain nearby, the ongoing math favors reverse osmosis: no electricity for the separation itself, a predictable cartridge schedule, and output that keeps up with a family’s daily use instead of a few gallons at a time. Distillation earns its place in smaller, specific jobs rather than as the household’s everyday drinking water source, mostly because the energy and the scrubbing add up the same way every single day it runs.

Is distilled water the same as reverse osmosis water?

No. Both end up low in dissolved solids, but they get there differently and are not identical. Distillation removes minerals more completely since nothing with their boiling point travels with the steam, while reverse osmosis rejects most dissolved salts through a membrane but can let some low-boiling VOCs and a small fraction of minerals through, depending on the membrane’s condition.

Does distillation remove more contaminants than reverse osmosis?

It depends on the contaminant. Distillation is stronger against minerals, heavy metals, and most microorganisms, which cannot travel with water vapor. Reverse osmosis is generally stronger against volatile and semi-volatile organic compounds with boiling points near or below water’s, since those can ride along with a still’s steam but are largely rejected by an RO membrane.

Why does distilled water taste flat compared to tap water?

Because distillation removes nearly all the dissolved calcium and magnesium that give tap water its taste. The same minerals are not a meaningful source of nutrition for most US diets, so the flat taste reflects a mineral change, not a safety issue. Reverse osmosis water can taste similarly flat unless the system includes a remineralization stage.

Can I put any tap water into a home distiller safely?

Usually, but check for volatile organic compounds first if the water comes from a well or an area with known solvent contamination, since simple distillers do not reliably remove them. A carbon filter ahead of the still, or a unit built with a vent and a carbon stage, reduces that specific risk. I am not a certified water treatment professional, so a confirmed VOC result deserves its own targeted fix rather than a distiller alone.